The Tower

$5,199.00
sold out

USD$3,599.00

We offer free shipping. Customs duties and import taxes, if any, are the buyer's responsibility.

Built for artists who want something bold and physical in their signal chain.

USD$3,599.00

We offer free shipping. Customs duties and import taxes, if any, are the buyer's responsibility.

Built for artists who want something bold and physical in their signal chain.

41" vertical spring reverb

Made in canada

four springs and all-analog signal path

The analog circuitry includes optocouplers for smooth control over compression, gating, feedback, and bypass.

It runs on 384 components, with only one digital chip used strictly for modulating analog signals.

smoked eucalyptus wood enclosure finished with solid brass plates

Inside, soundproofing shapes the tone, cutting harsh reflections and bringing out a warmer, moodier reverb.

The Tower delivers deep, dark, immersive reverb tones, designed for an intimate, personal experience between your guitar and your amplifier.

A remote foot switch is included for hands-free control during live use or recording sessions.

Important Notes:

The Tower was designed with amplifiers in mind. If you’re running it through a mixer, for example in a send and return setup, we recommend using a DI box and/or preamp to ensure proper gain staging.

For best performance, the unit should be grounded through one of its 1/4" jacks (excluding the foot switch jack).

Features

Efficient operation with included 18V, 1.4A power supply

Easily accessible on/off switch located above the DC input

Orange light indicates power and status

Connectivity features: input/output jacks, send/return jacks for external processing, throughput for signal routing, and remote footswitch jack with buffered bypass and feedback activation for a total of seven ¼” jacks

Gated reverb activation controlled by an on/off switch, dynamically triggered by input signal - Adjustment of attack, sustain, and release parameters for reverb response

Controls for vibrato depth and rate for modulation - Feedback section for adjusting intensity and trail length (applied to wet only)

Central mixer settings: wet, dry, and volume knobs, followed by return, dry, and wet controls for send/return jacks - Drive knob for boosting signal intensity into springs

Adjustable input knob with LED VU meter monitoring - Spring pick-up knob for fine-tuning reverb character

Single-knob compressor for enhancing reverb presence in the mix

additional information

Footswitch: remote with stereo ¼” TRS

Power supply: included

Input: ¼” TS Unbalanced

Output: ¼” TS Unbalanced

Current consumption: 560 mA

Power consumption: 11 W

Signal-to-Noise Ratio (SNR): approximately -30dB

Dimensions: 41" h x 8.5" w x 8.5" d (excluding remote foot switch)

Weight: 35lbs (excluding remote foot switch)